AMBISONIC LANDSCAPE COLLECTION™
11
The Square Bollard requires 2 adapter brackets to assemble the Square Sleeve over the
Mid-Range/Tweeter Port Tube, and secure it to the Subwoofer base.
Firstly, the Mid Bracket will be placed at the mid-length of the Port Tube unit, just below
the Mid-Range/Tweeter section. Attach the 2 halves of the Mid Bracket to this upper
section of the Port Tube
(See Diagram 5D • STEPS 1 | 2 • Page 12)
. The two Mid Bracket
halves should fit snugly together around the Port Tube, just below the Mid-Range/Tweeter
section. Secure the Mid Bracket halves to this upper section of the Port Tube, by inserting
4 Type B Screws (Phillips Pan Head), into the screw holes on the bottom of the bracket.
Using 1 screw to connect each side of the bracket, tighten the 4 screws upwards into the
upper section of the Mid-range/Tweeter Port Tube
(See Diagram 5D • STEP 2 • Page 12)
.
Once screwed into place, install the included Rubber Gasket, around the Mid Bracket
(See
Diagram 5D • STEPS 3 | 4 • Page 12)
.
Next, the Bottom Bracket will be placed at the bottom of the Mid-Range/Tweeter Port Tube
(See Diagram 5D • STEPS 5 | 6 • Page 12)
. The 2 Bottom Bracket halves should fit snugly
together around the bottom section of the Port Tube. Attach the Bottom Bracket halves to
the bottom of the Port Tube, making sure the two round grooves [Snap-Fit Latches] on the
Bottom Bracket are facing outwards & away from the Subwoofer
(See Diagram 5D • STEP
5 • Page 12)
. Simultaneously connect the Bottom Bracket halves together and into the
Subwoofer, by inserting 4 Type B Screws (Phillips Pan Head), into the screw holes on top of
the bracket, and tighten the 4 screws, downwards into the Subwoofer unit
(See Diagram
5D • STEP 6 • Page 12)
.
Now, the Square Sleeve should slide smoothly over the Mid Bracket and Bottom Brackets,
& the Port Tube, into the Port Hole Base of the Subwoofer. Ensure the 2 punched holes at
the bottom of the sleeve align with the 2 round grooves, [Snap-Fit Latches], on the base of
the Bottom Bracket on the Subwoofer
(See Diagram 5D • STEPS 7 | 8 | 9 | 10 • Page 13)
.
Once the sleeve slides down far enough, the 2 Snap-Fit Latches will snap & grip the sleeve.
Now, use the 8 Type A Screws (Phillips Flat Head), included in the packaging, with a Phillips
screw driver to secure the sleeve to the bracket structure.
(See Diagram 5D • STEP 10 •
Page 13)
.
5D. SQUARE SLEEVE ASSEMBLY
See Diagram 5B on Page 9, on adding Polyurethane Sealant, as recommended.
