7
7
Gas modulating output
Calculated from Set/Temperature -
Actual/Temperature.
0 - 5V output has a constant 1 volt supply
when there is no call for heat therefore the
GM44 (or other interface type) should be set
up to drop out at a voltage slightly above
this level.
For the Ambi-Rad Technical Department
telephone 01384 489700.
Before phoning it might be advisable to try
the following points:
If after installing the LCD display is blank
and the connections are correct the
AmbiTec Plus could need resetting this is
detailed below under clearing all settings.
Note The AmbiTec Plus control panel is fully
compatible with the MK2 Energy Mizor but
cannot be integrated with older style Energy
Mizor Master/Slave units.
Clearing password and/or setting’s is
achieved by the following instructions
(Remove this part of the page if security of
operation is important.
To clear all settings in the panel, turn OFF
the power and re-instate whilst holdings
the and the Select button.
To clear only the passwords, turn off the
power and re-instate whilst holding the
