Page
34
of
38
Alarms and Alarm Codes
If a fault or operation failure occurs within the heat pump
unit that triggers an alarm, the heat pump unit will shut down
until the fault is corrected or alarm is RESET
An alarm buzzer will sound on the heat pump display
controller
To view the alarm:
✓
Press the top left-hand ALARM button on the controller and
view the current Alarm
✓
If NO ALARM is present at this time, press the middle left hand
ENTER button, to view alarm history press the UP or
DOWN buttons to scroll through alarm history, find current
date and view alarm
NOTE: It is a good idea to write down alarms if they occur
Contact your installer if alarm continuously occurs
✓
To re set alarms, press and hold top left-hand alarm button
for 5 seconds, if heat pump fails to re start: Turn off Mains
Power Isolator located on the right-hand side of the heat
pump unit, leave OFF for 2 minutes and turn back on when
the heat pump control screen powers back up, press and
hold ALARM button for 5 seconds
*If alarm continues, please contact your installer
Summary of Contents for ASHP-23
