Version 1.0
©Copyright 2017, Ambient LLC. All Rights Reserved.
Page 9
3. Replace the battery door
4. Plug the AC adaptor into the DC jack of the console.
5. After power up, all of LCD segments will be displayed. The console will enter access
point (AP) mode, and the status LED will flash green.
6. Do not touch any buttons until sensor synchronization is complete.
Note:
If no display is present after powering up the console, press the
[RESET]
button on
the back of the console with an open ended paper clip or sharp tool.
3.3.2 Initial Sensor Synchronization
The console will automatically search for and connect to the indoor and outdoor sensors after
it is powered up. You can also press
[WI-FI / SENSOR]
button to force the console to search
for the sensors, and the c
onsole’s status LED will flash blue during the sensor(s) searching
mode.
Once the indoor sensor connection is successful, the antenna mark and readings for indoor
temperature & humidity will appear on the display.
Once the outdoor sensor connection is successful, the antenna mark and readings for
outdoor temperature, humidity, wind speed, wind direction, rainfall and UV will appear on the
display.
3.4 Mount the Indoor Sensor
The indoor sensor can be free standing on a table, or mounted on a vertical wall with a nail
ore screw. For best results, place between 10 and 100 feet of the display console.
Figure 6
3.5 Mount the Outdoor Sensor Array
3.5.1 Site Survey
Perform a site survey before installing the sensor array. Consider the following:
1. You must clean the rain gauge every few months and change the batteries every 2-3
years. Provide easy access to the weather station.
2. Avoid radiant heat transfer from buildings and structures. In general, install the sensor
array at least 5’ from any building, structure, ground, or roof top.