Version 1.0
©Copyright 2017, Ambient LLC. All Rights Reserved.
Page 20
[WIND]
means press but do not hold the
WIND
button on the top of the display.
5.9.3
Wind Speed Level
Figure 20
5.9.4
Calibrating the Wind Direction for the Southern Hemisphere
The outdoor sensor array is calibrated to point to the North when the solar collector is facing the
south. If you live in the Southern Hemisphere, you will need to point the solar connector to the North
and calibrate the wind direction 180 degrees.
1.
Point the wind sensor to the South instead of the North, as shown in Figure 7.
2.
Press and hold the
INDEX
button for eight seconds to enter UV index calibration mode, then
press the
INDEX
button again until the “
N
” icon appears on the weekday location.
3.
Press the [
]
button to change to the Southern Hemisphere. The “
S
” icon will appear.
4.
Press the
INDEX
button to confirm and exit.
Note: Changing the hemisphere setting will automatically switch the direction of the moon phase
on the display.
5.10 Barometric Pressure Display and Settings
Note: The barometric pressure sensor is inside the console. Barometric pressure is the same inside or
outside of your home or facility.
5.10.1
Barometric Pressure Units of Measure
In normal time mode, press the
BARO
button (on the top of the console) to change barometric units
of measure (hPa / inHg / mmHg).
5.10.2
Absolute Pressure vs. Relative Pressure
Press and hold the
BARO
button for 2 seconds to enter barometric mode, and press the
[ ]
button to
switch between the relative and absolute pressure reading.
5.10.3
Relative Pressure Calibration
Please Reference Section 5.10.3.1 for details on the purpose of calibrating relative pressure, and how
to calibrate relative pressure in your area.
1.
Press and hold the
BARO
button for 2 seconds to enter barometric mode. The icon
RELATIVE
or ABSOLUTE
will flash.
Make sure the
RELATIVE
Pressure is showing on the display. If
ABSOLUTE
Pressure is
showing, switch to
RELATIVE
pressure per Section 5.10.2.
2.
Press (do not hold) the
BARO
button again. The relative pressure will flash.
3.
Press the
[ ]
button to increase the relative pressure and the
[ ]
to decrease the relative