Version 2.1
©Copyright 2015,
Page 4
We recommend lithium batteries for cold weather climates, but alkaline batteries are sufficient for
most climates. We do not recommend rechargeable batteries. They have lower voltages, do not operate
well at wide temperature ranges, and do not last as long, resulting in poorer reception.
Replace the battery door and set screw. Note that the temperature and humidity will be displayed on
the LCD display. Looking at the back of the unit from left to right, the polarity is (-) (+) for the top
battery and (+) (-) for the bottom battery.
Figure 3
2.4
Display
Console
Set
Up
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Place the remote thermo-hygrometer about 5 to 10’ away from the display console (if the sensor is too
close, it may not be received by the display console).
Remove the battery door on the back of the display. Insert three AA (alkaline or lithium, avoid
rechargeable) batteries in the back of the display console. Looking at the back of the unit (left to right),
the polarity is (+) (-) for the top battery, (-) (+) for the middle battery and (+) (-) for the bottom battery.
The display will beep once and all of the LCD segments will light up for a few seconds to verify all
segments are operating properly.
Replace the battery door, and fold out the desk stand and place the console in the upright position.
The console will instantly display indoor temperature, humidity, barometer, tendency, date and time.
The remote search icon will turn on and should remain on for several minutes:
The outdoor temperature and humidity will update on the display within a few minutes.
Do not touch any buttons
until the remote sensor reports in, otherwise the remote sensor search
mode will be terminated and the search icon will turn off. When the remote sensor data has been
received, the console will automatically switch to the normal mode, and all further settings can be
performed.
If the remote does not update, please reference the troubleshooting guide in Section 7.