50D0104 RCSTE Rel 0 Feb 10 2006
Page 4 of 7
Ambient Technologies
A Division Of Monessen Hearth Systems
ON
DIP
ON
DIP
WARN
IN
G
Do not use two (2) or more remote control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
Reset Button
1. The reset button can be used to reset the transmitter if transmitter is not working properly. The reset button
is located behind the battery door cover. Using a paper clip, press the reset button and the transmitter will
reset and initialize for 10 seconds before it can be used.
OPERATIONS
Transmitter
General
The RCST Remote Control has two (2) operating modes: Manual and Thermostatic.
The control system can be set to temperature ranges between 45°F and 90°F.
The transmitter will operate the remote receiver from 1foot to a maximum of 30 feet.
The distance is reduced when batteries are low or when the receiver is inside a metal
enclosure.
Initial Start-up
1. After initial power up or when RESET button is pressed, the transmitter is
reset. The reset button is located inside the battery door.
2. During system reset, all features of the LCD display will be visible. After one
second, the LCD displays will be initialized. A typical reset display is shown beside.
Note that the temperature scale is degree F.
3. Press On button to select between °C and °F display. It will exit setting mode
automatically after 10 seconds if no key is pressed. The transmitter will send an Off
signal after reset.
4. After reset the transmitter is operating in manual mode. The room temperature is
shown as above.
Receiver
Dip Switch (Default)
Transmitter
f i r e - p a r t s . c o m
