Using the baby food nutrient blender
17
− Never run the mixing function with the mixing container for
more than 60 seconds.
− Wait a few minutes to let the appliance cool down before using
it again.
− Do not use this appliance to process frozen foodstuffs, or very
hard ingredients (such as nuts).
Remove all hard kernels from fruit, remove bones and gristle
from meat, and take the bones out of fi sh.
Chop larger pieces into approximately 1–2 cm diameter cubes before
placing them in the mixing container, so that they fi t without needing to
be squashed in.
Process larger quantities in several small portions, rather than all at once.
− Only connect the appliance to a properly installed power socket. The mains
voltage must match the technical data for the appliance.
− Place the milling container
1
/mixing container
3
, with the blade
holder
10
/
13
facing downwards, on the power base
8
. Make sure the three
lugs fi t into the three recesses on the power base.
To start the chopping function, twist the container clockwise.
You can pour liquids, such as vegetable oil, into the fi ller opening in the splash-guard
lid
2
on the mixing container when the appliance is running.
− Twist the fi ller opening cover so that the arrow points to the opened lock symbol.
You will now be able to open the fi ller opening and pour the liquid in through it.
Twist the cover until the arrow points to the closed lock symbol shows, to lock the
cover.
− Once the food has been chopped or blended enough, wait until the blades stop
moving.
− To cancel the chopping function, twist the mixing container/milling container
anticlockwise.
− When you have fi nished processing the food, pull the plug
9
out of the power
socket.
If bits of food (for example, if you're processing wet ingredients) remain
stuck to the inside of the container, switch the appliance off and use the
spatula supplied to remove them. Then put these pieces into the
container and chop them with two or three bursts of pulses.
− Lift up the mixing container/milling container with blade holder, vertically, to
remove it from the power base.
17852 EN-Aldi UK MSN 5005 8540 Content Final REV1.indd 17
17852 EN-Aldi UK MSN 5005 8540 Content Final REV1.indd 17
19.04.2018 13:31:44
19.04.2018 13:31:44
