1. Gently remove AIT210 cover using plastic pry tool from both sides.
2. Insert
Micro-SIM
card as shown with
PIN request disabled
or read our
Wiki
how to enter it later in
Amber Configurator
. Make sure that Micro-SIM card
cut-off corner
is pointing forward to slot.
3. Connect
battery
as shown to device. Position the battery in place where it does not obstruct other
components.
4. After
configuration
, see “
PC Connection
(Windows)”
, attach device
cover
back.
Mounting recommendations
•
Connecting wires
1. Wires should be connected while the module is not plugged in.
2. Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or
moving objects should be kept away from the wires.
3. There should be no exposed wires. If factory isolation was removed while connecting the wires,
the isolation material should be applied.
4. If the wires are placed in the exterior or in places where they can be damaged or exposed to
heat, humidity, dirt, etc., additional isolation should be applied and the wires should not be
loose.
5. Wires cannot be connected to the board computers or control units.
•
Connecting power source
1. Be sure that after the car computer goes to sleep mode, power might be still available on the
power wires. Depending on the car model, this may happen in 5 to 30 minutes period.
2. When the module is connected, measure the voltage again to make sure it did not decrease.
3. It is recommended to connect to the main power cable in the fuse box.
4. 3 A, 125 V external fuse shall be used.
•
Connecting ignition wire
1. Be sure to check if it is a real ignition wire i. e. power does not disappear after starting the engine.
2. Check if this is not an ACC wire (when key is in the first position, most of the vehicle
electronics are available).
3. Check if power is still available when you turn off any of vehicles devices.
4. Ignition is connected to the ignition relay output. As alternative, any other relay, which has power
output when ignition is on, may be chosen.
•
Connecting ground wire
1. Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.
2. If the wire is fixed with the bolt, the loop must be connected to the end of the wire.
3. For better contact scrub paint from the spot where loop is going to be connected.
LED indications
Navigation LED indications
Behaviour
Meaning
Permanently switched on
GNSS signal is not received
Blinking every second
Normal mode, GNSS is working
Off
GNSS is turned off because: Device is not working or
Device is in sleep mode
Blinking fast constantly
Device firmware is being flashed
