Use of the machine
84
ZA-M BAG0040.8 09.15
10.6
Notes for spreading slug pellets (e.g. Mesurol)
See the chapter on "Calibrating slug pellets" in the see operating in-
structions / software AMABUS.
The standard model
ZA-M
can also be used for wide-area spread-
ing of slug pellets. The slug pellets (e.g. Mesurol) may either be pel-
lets or have a pellet-like shape and are spread in relatively small
quantities (e.g. 3 kg/ha).
WARNING
When filling the spreader, avoid breathing in product dust and
direct skin contact (wear protective gloves). After the applica-
tion, thoroughly wash your hands and all affected areas of your
skin with soap and water.
DANGER
Some slug pellets can harm children and pets. Ensure that they
are stored in an area that is inaccessible to both children and
pets. Always refer to the directions for use from the slug pellet
manufacturer.
For additional information on handling slug pellets, refer to the manu-
facturer's instructions and the general safety precautions for handling
crop protection agents (in Germany, data sheet No. 18 of the Federal
Biological Research Centre for Agriculture and Forestry (BBA)).
•
When spreading slug pellets, ensure that the outlet opening are
always covered with product and make sure to always drive at a
constant speed. A residue of approx. 0.7 kg for each hopper tip
remains, which is impossible to spread according to the intended
use of the fertiliser. To empty the spreader, open the slider and
catch the flow of product (using a tarp, for example).
•
For the spreader settings, refer to the separate setting chart for
green manure seed, grain and slug pellets (optional). This infor-
mation can serve as guide numbers only. Carry out a spread
rate check before use.
Due to the low spread rate, it is recommended that the neces-
sary calibration distance is increased by at least three times. The
multiplier for the spread rate conversion reduces in this case to
a third of the specified value (e.g. for 9 m working width: multi-
plier 40 : 3 = 13.3).
•
Slug pellets must
not
be mixed with fertiliser or other materials
in an attempt to operate the spreader in a different setting range
