Use of the machine
80
ZA-M BAG0040.8 09.15
The fertiliser spreader is operated using the control terminal.
See operating manual for software AMABUS.
•
The fertiliser spreader is coupled to the tractor and the hydraulic
hoses are connected.
•
The settings have been configured.
1. Activate tractor control unit
red
and switch
on
hydraulic fluid
supply for the control block!
→
Switch all hydraulic functions using the control terminal.
•
Never open the two slide gates until the required universal joint
shaft speed has been reached.
•
Set the spreading disc speed to 720 rpm unless indicated other-
wise in the setting chart.
•
Always carry out a spread rate check or turn on the online cali-
bration at the beginning of the spreading process.
2. Open the slide gates hydraulically and drive to the spreading
area.
3. When you have finished spreading:
3.1 Close the slide gates.
3.2 Activate tractor control unit
red
and switch
off
the hydraulic
fluid supply for the control block!
•
After long transport with a full hopper, ensure that the yield is
correct before spreading begins.
•
If, despite an identical shutter position, you determine that the
two hopper tips are not emptying uniformly, check the basic set-
ting of the sliders.
•
The service life of the spreading vanes depends on the kinds of
fertiliser used, the operating times and the spread rates.
