2. See "Determining the pulses per 100 m" in the
control computer operating manual
or
refer to the ISOBUS operating manual, "Setting
up the speed sensor on the implement".
6.4.13 Using the multi-placement tester
6.4.13.1 Determining the grain size
Determine the grain size of the seed with the multi-
placement tester.
1. Put the seed in the reference holes
1
.
2.
If the seed lies loosely on the reference hole,
read the hole diameter.
1
CMS-I-00001217
6.4.13.2 Checking the grain spacing
The spread rate determines the required grain
spacing. The grain spacing is adjusted by selecting
the singling discs and adjusting the singling disc
speed.
1
CMS-I-00002011
1. Seed approx. 30 m at working speed.
2. Use the read-off edge of the multi-placement
tester to remove the earth in layers.
CMS-T-00005293-B.1
CMS-T-00001888-B.1
CMS-T-00002354-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6967-EN-II | C.1 | 27.09.2021
90
