Cleaning, maintenance and repairs
11.5
Slide bearings of offset slide
(Workshop work)
Replace slide bearing at approx. 4 mm clearance.
To replace the slide bearings (Fig. 54/1), place
the folded-out machine down so that the slide
bearings are free from tension.
The disc units must touch the ground, but must
not support the weight of the machine!
If necessary, support the disc units!
•
Each disc unit has two slide bearings.
1. Release the screw union (Fig. 54/2) of the
shifting shaft (Fig. 54/3).
2. Drive the shifting shaft out of the bearing.
3. Remove the circlips from the slide bearing.
4. Replace the slide bearing.
5. Fit the circlips.
6. Reinstall the shifting shaft and secure with a
screw union.
Fig. 54
11.6
Drawbar
Check the bolts for tightness.
Required tightening torque: 620 Nm.
Fig. 55
11.7
Roller (Workshop work)
To replace the roller (Fig. 56/1), place the folded-
out machine down so that the roller is free from
tension.
1. Release screw union (Fig. 56/2).
2. Withdraw sleeve (Fig. 56/3).
3. Replace roller as required.
4. Fit sleeve.
5. Tighten screw.
Fig. 56
78
Catros BAG0081.10 09.14
Summary of Contents for Catros 4001-2TS
Page 89: ......