Amaranten F1800 Series, Installation And Setup Manual

Page: 18 / 34

Chapter 3. Initial Setup
• Attaching Connectors, page 12
• Setup with local RS232 console, page 14
• Setup with Display and Keypad, page 16
• Finalizing the Configuration, page 17
3.1. Attaching Connectors
3.1.1. Connecting to a Network
The initial configuration of the F 18 00 Series device configures which Ethernet interface is to be used
for remote management. Any interface can be used for this purpose. The selected interface can also
be used for normal traffic.
The intended interface should be attached to the same network as the management server (or a net-
work accessible from the management server via one or more routers).
Connect the interface to a switch or hub in the network using a regular straight-through Ethernet
cable. In the diagram below, the Amaranten appliance (unit top-left) is connected to a switch
(bottom-left).
Figure 3.1. A typical installation setup
The F 18 00 Series device can be connected directly to the network interface of the management server
without using any switch or hub, but please note that in that case, a crossover cable must be used.
The final phase of the initial set-up requires actions performed using either the F 18 00 Series Console
port or using the display and keypad on the front of the device (see Section 3.3, “Setup with Display
and Keypad”).
3.1.2. Connecting the Console Port
The serial console port is an RS-232 port that enables a connection to a PC or terminal for monitor-
ing and initial configuration of the F
18 00 Series device. To use the console port, you need the follow-
ing equipment:
12