12
OPERATION
The fireplace can be operated either by the switches located on the left front of the fireplace
unit or by supplied remote control.
MANUAL OPERATION
1. The main power ON/OFF switch in position O, the fireplace is OFF.
2. When main power ON/OFF switch is at position I, the fireplace is ready to use.
3. Press the
Heat
button repeatedly to set the heater to desired heat setting. The heater
indicator LED will glow which shows the current heater settings.
a) RED 1500W HEAT OUTPUT
b) BLUE 750W HEAT OUTPUT
c) PURPLE AUTO MODE
AUTO MODE
Under this mode the heater will automatically turn ON at high heat setting 1500W heat output
when the room temperature drops below 22
. When the room temperature is between
℃
22-25
the heater output will switch to low heat setting
℃
750W.When the room temperature
goes above 25
the heater will be turned off and the cycle will continue
℃
. The LED indicator
will be PURPLE in colour under this mode.
4. Flame effect: Press the button marked
Flame
to adjust the flame brightness. The flame
brightness will cycle through
–
Low-Medium-High -OFF.
NOTE:
If operated at the Low heat setting, the fireplace will not provide as much heat output
as in the High heat setting, however the low setting will not require as much electrical power
to operate. To avoid overloading a circuit, do not plug the fireplace into a circuit that already
has other appliances working. When the fireplace is not in use switch off and unplug.
SAFETY CUT-OFF
l
This appliance is fitted with a safety cut-off which will operate if the fireplace overheats
(eg. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically
reset.
l
To reset the appliance, disconnect the appliance from the mains supply for at least 10
minutes. Reconnect the supply to the mains and switch on the appliance.