Amano PR600 Series, Handling Manual

Page: 8 / 12

6 PR600 Handling Manual
4.
How to Install the Roll Paper (Refer to Fig. 3, & 7).
•
Set the clock by turning the
time adjustment knob [10] as
shown in Figure 7 either
clockwise, or counter
clockwise.
•
Check the time of the
typewheel by printing on the
roll paper.
•
Hold the seconds adjuster (4)
as shown in Figure 7 to stop
the clock from advancing.
Note: Whether it is morning or afternoon,
because the hourwheel will only show 0 – 23. The minutes will
print in two minute increments such as, 00, 02, 04, 06, 08, 10,
12……56, 58, & 60.
5. How to Adjust the Date (Refer to Fig. 3, & 7).
•
The date typewheel has been preset to imprint “1”. Press the
feed lever (Date) [5] towards the arrow to advance the date
typewheel to the correct date.
•
Ensure the imprinted date is correct by using the master (K) key.
•
At the beginning of each month you must adjust the date as date
adjustment is not automatic.
•
If required, repeat the same action detailed in Step 3 – How To
Set Roll Paper.
6. How to Remove the Roll Paper (Refer to Fig. 5, & 6).
•
Turn the paper winder [7] counter clockwise until the last
registration (imprint) is visible past the paper winder.
•
Pull out the paper winder, and cut the paper tape after the last
registration.
•
Replace the paper winder [7], pushing down hard to the original
position. The paper winder must be placed in the proper position
to obtain a clear imprint.
Figure 7.