PIX-95 www.amano.com
1-800-253-9836
pg. 10
.
Disabling or Enabling the Atomic Clock
By default, the Atomic Clock function is enabled. If you wish to disable the atomic
clock synchronization, or if you wish to re-enable synchronization, please do the
following:
1. Press and hold the
PROGRAM
button until
appears.
2. Press the
CHANGE
button until
appears.
3. Press the
ENTER
button.
4. Press the
CHANGE
button until
flashes in
the display. Press the
ENTER
button.
5. Press the
ENTER
button to move to the second digit and
press the
CHANGE
button until the last digit of the code is
the number (to disable atomic clock) or the number (to
enable atomic clock).
6. Press
ENTER
to accept. The display will flash and code
or
will show on the display, press
ENTER
to
accept. The display will show
7. Press the
PROGRAM
button to exit.
Ribbon Cartridge Replacement
1. Remove the cover.
2. Pull the two ribbon release tabs upward.
3. While holding the release tabs in an upward
position, pull the ribbon cassette out of the cradle.
4. If the print mechanism is down and a piece of
paper cannot be inserted, unplug the clock, then
plug it back in to move the carriage up. This will
make the ribbon installation easier.
5. Insert a new ribbon underneath the printer head
as shown.
6. Turn the knob on the cassette clockwise one turn
to take up any slack in the ribbon.
7. Check the printing quality to confirm that you have
installed the ribbon properly.
8. Reset the INK capacity gauge by pressing the
CHANGE
and
ENTER
buttons at the same time
9. Replace the cover.