10. Remove the 1/4” bolt from the center of each driver
assembly. Remove the driver assembly from the
gearbox shaft. (
Note: Slowly threading a 3/8”-16 X
4” Tap Bolt into the bottom of the driver assembly will
push the driver assembly off of the gearbox shaft
).
11. Remove the drive belt from the gearbox pulley.
12. Remove the two 3/8” bolts that attach the gearbox
support brace to the gearbox assembly.
13. Remove the (8) bolts that attach the gearbox
assembly to the deck. (
Note: Mark the gearbox
assembly so that it cannot be installed on the
machine backwards
).
14. (
Note: This step requires a hoist or the assistance of
another person.
) Tilt the gearbox assembly toward
the front of the machine and lift off the deck.
Changing Gearbox Oil
1. Remove the oil plug from each gearbox (3).
2. Tilt the gearbox assembly over on its side so that the
oil can drain.
(Note: Place a catch pan under the
assembly.)
3. After the oil has drained, turn the gearbox assembly
over on the other side so the fill ports are turned up.
4. Add 16oz. (473 ml) AGMA 5EP Gear Lubricant or
equivalent gear lubricant to each gearbox.
5. The oil level in each gear box should be just below
the bottom of the oil drain port when the gearbox
assembly is setting upright on a level surface.
WARNING!
ALL GEARBOXES MUST BE FILLED
TO PROPER LEVEL WITH RECOMMENDED
LUBRICANT BEFORE OPERATION.
6. Install plug in each gearbox using a thread sealant
and properly tighten.
7. Dispose of used oil properly.
8. Check gearbox oil level every 100 hours and add oil if
needed.
31
Summary of Contents for Pioneer Eclipse 450GP
