![background image](http://html1.mh-extra.com/html/amano/mtx-15/mtx-15_installation-manual_2918225012.webp)
Page 10
MTX-15
Wall Mounting and Initialization
Once connections have been made the terminal can be mounted and
initialized. To do so perform the following:
1. Holding the terminal face down, pull and remove the green paper
insulating strip from under the battery.
2. Re-install the terminal on the back plate by placing the notch on the
bottom of the Back Plate (see page 3) over the plastic tab in the
bottom of the terminal cabinet. Pivot the terminal up so the locating
pin on the Back Plate aligns with its corresponding hole in the cabinet.
Rotate the key counterclockwise to lock the terminal in place. Remove
the key.
3. Plug in the AC Power Adapter into an outlet. The terminal will do the
following after displaying opening splash screens:
•
Test memory banks “0” through “6” and report the results.
•
Report the serial number of this terminal.
•
Report the communication type of this terminal: serial
(RS232/RS485), Modem or Ethernet.
•
Test the keypad and if OK, report the keypad version.
•
Display the version of firmware installed.
•
Display the Terminal Number (always “0” until re-assigned by
Time Guardian software).
•
Display the opening screen.
Note: The time and date cannot be set from the keypad; it must
be downloaded to the terminal from the host PC. Pressing any
numeric key will display “E04 Keypad Lock”. All features and
functions must be enabled from the host.