Amano 07082C, Operator'S Manual

Page: 9 / 88

9
Machine Setup
EN
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Listed below are the tools needed for setup of the machine:
1 - #2 Phillips screwdriver
2 - ½” open end wrenches or (2) adjustable wrenches.
To prepare the machine for use, follow this procedure:
1. Remove all components of the machine from its package and
check for damaged or missing parts.
2. Read Operation and Parts Manual, including all danger, warn-
ing, and caution statements before operating the machine. If
you or the operator are unable to read the language this manual
is printed in, have the manual fully explained before attempting
to operate this machine.
3. Attach the sanding unit to the truck frame by securing the two
hand knobs through the truck frame to the sanding unit. (see
Figure 6). The eccentrics in the truck frame should be used for
proper alignment between the truck frame and sanding unit. Match
tick marks on spacers and frame; one on right and two on left.
4. Route the motor power cable under the head pressure strap
and vacuum support strap, then over the tilt assist strap.
5. Secure the handle assembly to the truck frame by bolting it on
with the four 5/16-18 bolts and nyloc nuts supplied and plug in
motor power cord. (see Figure 7) Tighten the nuts that hold on the
tilt wheels and attach the vacuum support straps as per figure 7.
6. Put Dacron filter around the cloth filter. (See Figure 8)
7. Set the dry vacuum on the vacuum support straps with the
center bottom in the 2” diameter hole. NOTE: The vacuum
hose port should be facing the sanding unit motor. Attach the
vacuum strap around the base of the vacuum. (See Figure 9)
8. An optional disposable paper bag is available. If you wish
to use the paper bag, remove the vacuum head and install a
paper dust control bag by inserting the deflector on the vacuum
into the mounting shoe of the paper bag. To ensure the bag
is properly seated on the deflector, the rubber seal should rest
in the groove of the deflector (See Figure 10). NOTE: Check
the paper bag for proper seating after transport to avoid dust
in the vacuum tank.
9. Wrap the vacuum cord around the cleats located on the back
of the handle. Leave enough slack in the cord to plug into the
electric box. Turn the vacuum switch to the “ON” position. The
vacuum switch should remain in the “ON” position. (See Figure
11 below)
Figure 11






