Amana W10773366A, Use And Care Manual

Page: 13 / 32

13
Troubleshooting
If you experience Possible Causes Solution
Dryer Operation
Dryer will not run Door not closed completely. Make sure the dryer door is closed completely.
Press and hold the START button
2–5 seconds.
Press and hold the START button 2–5 seconds.
Household fuse is blown or circuit
breaker has tripped.
There is be a household fuse or circuit breaker for the dryer.
Check that the fuse is intact and tight, or that the circuit breaker
has not tripped. Replace the fuse or reset the circuit breaker. If
the problem continues, call an electrician.
Incorrect power supply. Electric dryers require 120-volt power supply.
Check with a qualified electrician.
Wrong type of fuse. Use a time-delay fuse.
Incorrect power supply. Electric dryers require 120-volt power supply.
Check with a qualified electrician.
Timer does not
noticeably advance
Dryer set to Timed or Air Dry The timer moves slowly and continuously for the time setting.
Dryer set to Auto Dry The timer moves only when the clothing is mostly dry. See “How
Auto Moisture Sensing Works” in “Dryer Use.”
Unusual Noise
Thumping noise Dryer hasn’t been used in a while. This is normal. The thumping sound should diminish after a few
minutes of use.
Rattling or vibrating noise A small object caught between the
edges of dryer drum.
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
Dryer isn’t properly leveled. The dryer may vibrate if not properly installed. Check the
levelness of the dryer. All four casters should be in firm contact
with the floor.
Clothing is balled up in dryer. When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
First try the solutions suggested here or visit our website at www.amana.custhelp.com -
In Canada www.amanacanada.ca for assistance and to possibly avoid a service call.
Dryer Results
NOTE: The compact dryer operates at a lower wattage. Expect longer drying times.
Clothes are not drying
satisfactorily or drying
times are too long
Lint screen is clogged with lint. Clean lint screen before each load.
The exhaust vent or outside exhaust
hood is clogged with lint, restricting
air movement.
Run the dryer for 5–10 minutes. Hold your hand under
the outside exhaust hood to check air movement. If you
do not feel air movement, clean exhaust system of lint
or replace exhaust vent with heavy metal or flexible metal vent.
See “Venting.”