10
1
3
Multiple Cooking Stages
Follow instructions below to program oven to perform up
to four consecutive cooking cycles without interruption.
Example: Program third cooking sequence to heat for 30
seconds at 20% power, 40 seconds at 50% power, and
10 seconds at 100% power.
1. Open oven door.
Display shows READY. Fan and light operate.
If door is closed or RESET pad is pressed before
finishing programming sequence,
oven exits programming mode.
2. Press and hold pad 1 for
approximately 5 seconds.
After 5 seconds, signal sounds.
Display shows P:
3. Press 3 pad to select memory pad.
Display shows cooking time and
power level if other than 100 percent
power.
4. Press 3 and 0 to enter desired cooking
time.
5. Press POWER LEVEL pad to change
power level.
Display shows current power level if
other than 100 percent power.
6. Press TIME ENTRY pad.
Display briefly shows "P:3
(2)
"
indicating programming, pad 3, stage
2. Then cook time and power level for
stage show in display.
Repeat steps 57 to create additional
stages.
7. Press START pad to save new cooking
time and power level in oven memory.
8. Press STOP/RESET pad or close oven
door to exit programming mode.
DEFROST
20%
3
0
TIME
ENTRY
START
STOP
RESET
Memory Pads
Follow instructions below to program cooking times and
power levels for customized cooking. Example: Program
third cooking sequence to heat for 30 seconds at 20%
power.
1. Open oven door.
Display shows READY. Fan and
light operate.
If door is closed or RESET pad is
pressed before finishing programming
sequence, oven exits programming
mode.
2. Press and hold pad 1 for approximately
5 seconds.
After 5 seconds, signal sounds.
Display shows P:
3. Press 3 pad to select memory pad.
Display shows cooking time.
4. Press 3 and 0 pad to enter desired
cooking time.
5. Press POWER LEVEL pad to change
power level.
Display shows power level if other than
100 percent power.
6. Press START pad to save new cooking
time and power level in oven memory.
Display shows P:.
Repeat step 36 to program additional
pads.
7. Press STOP/RESET pad or close oven door to exit
programming mode.
DEFROST
20%
START
STOP
RESET
1
3
3
0
