5-12
CONDITION
CHECK
RESULT
CAUSE
REMEDY
1. Fuse blows.
Continuity.
No continuity.
Continuity.
Shorted contact at
the primary switch.
Replace fuse,
primary, monitor
and secondary
switches.
No continuity.
Malfunction of the
monitor switch.
Replace fuse,
primary, monitor
and secondary
switches.
Check continuity
of monitor
switch (with
door closed).
Check continuity
of primary
switch (with
door opened).
Replace fuse
2. Fuse does not
blow.
No continuity.
Continuity.
No continuity.
Defective power
supply cord.
Replace power
supply cord.
Defective
thermostat.
Replace
thermostat.
Check continuity
of thermostat.
Check continuity
of power supply
cord.
(TROUBLE 1) Oven does not operate at all
NOTE : All these switches must be replaced at the same time. Refer to page 5-8
Normal.
Normal.
Abnormal.
Defective high
voltage capacitor.
Replace high
voltage capacitor.
Set is good condition
(defective fuse only)
Fuse blows again
Defective high volt-
age transformer.
Replace high volt-
age transformer.
Disconnect one
side of the wire
lead connected
from transformer
to the high voltage
capacitor and
operate the unit.
Measure to
resistance high
voltage capacitor
(refer to page 5-9)
Summary of Contents for LD510D
