5
Dispensers
Fabric Softener
Dispenser
Fabric softener dispenser is
located on top of agitator.
Dispenser automatically releases
liquid fabric softener at proper time
during rinse cycle.
Fabric Softener Use Tips
• Liquid fabric softeners are
dispensed during final rinse. Do
not combine with bleach, bluing,
starch, detergents, soaps, or
packaged water conditioners
during rinse.
• Do not use fabric softener in
dispenser during DOUBLE WASH
cycle.
• Do not mix powdered detergent
with liquid softener in dispenser or
softener will become gummy.
• To prevent build-up, fill dispenser
with clean water in wash cycles
when not using softener.
Fabric
softener
dispenser
To use dispenser, follow these steps:
1.
Pour liquid fabric softener into dispenser, using amount recommended
on package.
2.
Add water up to fill level, but do not exceed tip of fill arrow indicator.
FABRIC SOFTENER MUST BE DILUTED FOR USE.
• Do not stop washer during first spin or dispenser will empty too
soon.
• Never pour fabric softener directly onto clothes or spots and stains
may result. To remove softener stains, soak in soapy solution of
Sard
™
Wonder Soap or Ivory
™
soap, or rub stain with bar of Sard
™
or
Ivory
™
soap and wash garment as usual.
• For best softener performance, set water level to medium or higher.
Bleach Dispenser
Bleach dispenser is located in left
front corner under loading door.
Bleach
dispenser
Use only liquid bleach in
dispenser. To use powdered
bleach, add to wash tub with
detergent.
Carefully pour recommended amount
of bleach into dispenser during first
washer fill. See table.
Be careful not to spill undiluted
bleach. It is a strong chemical and
can damage cabinet finishes and
some fabrics if not properly diluted.
Follow bleach manufacturer’s label for
proper use.
LOAD SIZE
BLEACH
(Max Amt.)
SUPER PLUS
1 cup
LARGE
1 cup
MEDIUM
3
/
4
cup
MEDIUM/SMALL
½ cup
SMALL
½ cup
Housing
base
3.
Clean softener dispenser after each use.
Remove dispenser housing from agitator by
squeezing lower part of dispenser and
pulling up on housing. Housing should
snap loose. Rinse dispenser housing,
dispenser cup (not shown), and
housing base, in hot soapy water.
Clean inside of agitator. Use small brush on hole
and slots in two funnel rings for thorough cleaning.
After cleaning, replace housing base and dispenser cup. Push
dispenser housing directly down onto top of housing base until base
and housing firmly snap together.
Dispenser
housing
