5
Cooktop Cartridges
Which cartridge should you use?
Your cooktop comes with two gas burner cartridges, but by adding
accessories, you can customize your cooktop to suit your specific needs.
CARTRIDGE TYPE
BURNER TYPE
PLACEMENT
Burner (standard)
Two gas burners
Larger front burner, smaller
rear burner.
Grill (accessory)
Gas grill burner
Can be installed right side
only.
Griddle (accessory)
Gas grill burner
Installed on top of grill
accessory.
To install the gas burner cartridge:
1. Turn all controls to OFF.
2. Verify surface of cooktop is cool to the touch.
3. Hold cartridge with venturi pointing toward rear of cooktop.
If cartridge pan from grill or griddle cartridge is in the well, remove before installing the cartridge.
4. Place end of cartridge into cooktop well with venturi facing rear of well.
Lifting cartridge over 45° angle can cause damage to
cartridge terminals.
5. Slide cartridge towards rear of cooktop until cartridge
engages. Lower front of cartridge into well.
6. Place burner caps on burner
The cap should not be loose.
The pegs in the burner base should fit into the
recess on the underside of burner cap.
Cap should be the correct size for each burner base.
Cap must be clean and dry for proper ignition.
Once cap is properly placed, place grate over cap and burner base .
To remove burner cartridges:
1. Turn all controls to OFF. Make sure surface is cool.
Do not tilt cartridge too high.
Lifting cartridge over 45° can cause damage to burner venturi.
2. Remove burner grate and cap.
3. Using tab on front of cartridge, lift up slightly.
4. Pull cartridge toward the front of cooktop and carefully lift out.
WARNING
!
To avoid personal injury, do not
touch surface burners or area near
burners.
Surface burners may be dark in
color even when hot.
Areas near burners may be hot
enough to burn.
Do not allow clothing or other
flammable materials to touch
cooktop during or after use.
WARNING
!
To avoid personal injury, all
controls must be in OFF position
before removing or installing
cartridges.
