8
Adjusting Surface Burner Flame
1. Turn controls to
OFF
position.
2. Remove grate and burner caps from cartridge.
3. Remove cartridge according to
Cooktop Cartridges
.
4. Locate air shutters on rear of cartridge.
5. Adjust each air shutter using small screw driver.
Slide air shutter until shutter is approximately
1
/
8
inch open.
6. Replace cartridge according to
Cooktop Cartridges
and check for proper
flame.
7. Replace burner grate when flame is properly adjusted.
Adjusting Surface Burner Flame
Placing burner caps
Burner cap must be correctly seated on the burner base for proper operation
of the burner. Verify cap is properly aligned and leveled by moving the
burner cap around on burner base while cooktop is cool.
The cap should not be loose.
The pegs in the burner base should fit into the recess on the underside
of burner cap.
Cap should be the correct size for each burner base.
Cap must be clean and dry for proper ignition.
Once cap is properly positioned, place grate over cap and burner base.
JUDWH
EXUQHUEDVH
EXUQHUFDS
Testing and adjusting surface burner flame
A properly adjusted surface burner on a high setting has flames that are
clean and blue with a distinct inner cone approximately
1
/
4
to
1
/
2
" long.
See
Delayed Ignition
section in Important Safety Information for safety
warnings and procedures.
Flames will not be a uniform size around the cap. This
distribution around the cap and grate allows for optimal heating.
If burner flame is blowing or noisy, airflow should be reduced to
the burner (close air shutter).
If burner flame is weak and does not hold its shape, airflow should be
increased to the burner (open air shutter).
Adjustments must conform to all local, municipal and state building
codes, and local utility regulations.
1/2"
Open
Close
Adjusting Grill Cartridge Burner Flame
1. Turn controls to
OFF
position.
2. Remove grill or griddle from cartridge if necessary.
3. Remove cartridge according to
Cooktop Cartridges
.
4. Locate air shutters on rear of cartridge, loosen air shutter lock screw,
and open or close air shutter.
Tighten air shutter lock screw after adjusting.
5. Replace cartridge according to Cooktop Cartridges and check for proper
flame.
%XUQHU
