Amadas RMH1000M, Manual

Page: 17 / 52

RMH1000M Safety
Remove Paint/Protective Coating
Before Welding Or Heating
•
Avoid potentially toxic fumes and dust.
•
Hazardous fumes can be generated when
paint or coatings are heated by welding,
soldering, or by using a torch.
•
Do all work outside or in a well-ventilated
area.
•
Remove paint/coatings before welding or
heating:
o
If you sand or grind paint, avoid
breathing the dust. Wear an approved
respirator.
o
If you use solvent or paint stripper,
remove stripper with soap and water
before welding.
o
Remove solvent or paint stripper
containers and other flammable
material from the area.
o
Allow any fumes to disperse for at least
15 minutes before welding or heating.
•
Do NOT use a chlorinated solvent in areas
where welding will take place.
•
Do all work in an area that is well-
ventilated to carry toxic fumes and dust
away.
•
Dispose of paint/coatings and solvent
properly.
Avoid Using Heat Near
Pressurized Fluid Lines
•
Flammable spray can be generated by
heating near pressurized fluid lines,
resulting in severe burns to yourself and
bystanders.
•
Do NOT heat by welding, soldering, or
using a torch near pressurized fluid lines
or other flammable materials.
Pressurized lines can accidentally burst
when heat goes beyond the immediate
flame area.
NOTE! This section covers general safety. Some items may not apply to this type of machine.
Keep Riders off of Machine
•
Only allow the operator on the machine.
Riders obstruct the operator’s view,
which results in the machine being
operated in an unsafe manner.
•
Riders are subject to injury such as
being thrown off of the machine.
•
Children should NEVER be allowed on
the machine.
MAN137 05/29/15 7