• Check package contents against supplied parts and hardware list to assure
that all components were received undamaged. Do not use damaged or
defective parts. lf you require replacement parts, please contact amada
customer service at
• Carefully read all instructions before attempting installation. If you do not
understand the instructions or have any concerns or questions, please
contact customer service at
.
• Not all parts and hardware included will be used.
• Do not use this product for any purpose that is not explicitly specified in
this manual. We cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use. Thank you for your understanding.
IMPORTANT SAFETY INFORMATION
Supplied Parts and Hardware
Specification
Tray
B (x1)
Connector
C (x1)
M4x10 mm
Bolt
D (x4)
Step 1
Adjust the Height of the Tripod
01
02
03
H
eig
ht
A
dju
st
ab
le
Foldable Tripod Stand
A (x1)
Slightly loosen the knob.
1-2
1-1
When you adjust the pillar to your desired
height, tighten the knob, then insert the
safety pin into the hole on the pillar.
Phillips
Screwdriver
(Not Included)
Warning:
When you unfold or
fold the tripod, please be careful and
avoid pinch areas such as the upper
section of the supporting leg. DO
NOT place hands on or near the
joints of the supporting leg.
Height Adjustable
26 in - 51 in
(660 mm - 1295 mm)
16.0 in
（406 mm）
11.0 in
（280 mm）
Loosen
Tighten
Summary of Contents for AMPS02
Page 3: ...1 2 3...
