Apr-17
13
Plastic Installation
For security reason, the motor will be stop when you open the side door to install the
plastic roller, ( photo #3 p. 11)
Need to reset to restart (reset button picture #5 p.17)
The plastic must be treaded over the slave roller and then through the two red rollers on
the tensionner as shown on the diagram.
The two black stretcher rollers rotate at different speeds. This induce the plastic to be
stretched. It is very important that the plastic go over the slow roller first and the faster
roller second. The faster roller should be marked by a red dot opposite it on gear case.
If there is any question of which is the fast roller
(For the serial numbers up to 345.)
1)
Place a pen mark on each roller and rotate one roller one turn.
2) Check the location of the marks on the other roller.
● If it has advanced further then, it is the fast roller.
● If it has advanced less, it is the slow roller.
When the plastic is installed properly, it should stretch film tight on the bale to form a
smooth linear tube.
Summary of Contents for Stretch-O-Matic 7500
Page 2: ...Apr 17 2...
