Supported swashplate types
4. LED indications
Red light
Working in tail lock gyro mode
Blue light
Working in the non tail lock gyro mode
Red and blue light
Gyro has not received any signal
Red and blue lights flashing
Initialization failed, please keep the gyro still
and the rudder stick at center
Red light keeps flashing
Gyro in firmware upgrade mode
5. Gyro installation
◆
the gyro should be installed in a vertical or horizontal alignment on a stable platform, as far as possible away
from the engine and other electronic devices.
◆
the gyro should be installed using double-sided foam adhesive between the gyro bottom and gyro mount. To
prevent transferring fuselage vibration to the gyro, make sure the cables are not pulled too tight and that the
case does not touch any other helicopter component.
◆
when installed in small electric helicopters, use a 2mm or 3mm foam double-sided adhesive pad.
◆
when installed in a large helicopter or when there is helicopter vibration, it is recommended to use a metal
plate between two foam double-sided adhesive pads.