Outboard Racing Starting Clock
User Manual
Assembly & Installation Instructions:
Unistrut Stand Assembly (see online video for
additional instructions – http://sports-
timer.com/boat-race-clock/
):
Tools Required – 9/16 Socket Wrench, 9/16 Box Wrench
Hardware Included– 12 pieces 3/8”x0.75” hex bolts; 8 pieces
3/8”x1” hex bolts; 4 pieces 3/8”x1.5” hex bolts; 4 pieces 3/8”x2” hex
bolts; 24 pieces 3/8” channel nuts; 32 pieces 3/8” flat washer; 2 L-
brackets; 2 Reinforced L-brackets
•
Mark the holes you're going to use on the struts
•
3' Foot Pieces – mark between the 7
th
and 8
th
hole from each
end, the 8
th
hole serves as the outer hole for each bracket
•
5' Upright Pieces – bracket the 9
th
hole from one end with tape
and the 3
rd
hole from the other end for one piece,
•
10' Horizontal Cross Pieces – bolt holes 7
th
and 15 away from
that plus the one after it and another 15 away from that, then do
the same from the other end of the bar
•
Attach L-brackets to the 3' foot pieces using 3/8”x1” hex bolt,
flat washer, 3/8” channel nut (drop nut into channel and rotate
into place) – first by hand, then using the 9/16” Socket or Box
Wrench –
Before tightening fully, insert an Upright piece
between brackets to ensure proper spacing
•
Attach 5' Upright Piece by sliding channel between the two L-
brackets then use 3/8”x2” hex bolts and flat washers to fix in
place – Tighten with 9/16” Socket and Box Wrenches –
front of
strut must be facing direction of the reinforced L-brackets
•
Attach 10' Horizontal Cross Pieces – Take 3/8” channel nut and
put it into the Upright Piece channel then slide a flat washer
over the 3/8”x1.5” and install through the Horizontal Cross
Piece into the Upright Piece; repeat process for second
Horizontal Cross Piece
Display Assembly:
•
Lay display face down
•
Take Unistrut Stand and lay it on top of display
•
Bolt Unistrut Stand to display before standing display up –
Note: Display must be fully disassembled to use the Race
Clock Cover
Unistrut Stand Take Down:
•
Lay display down
•
Loosen and remove bolts
•
Remove struts –
Note: Display must be fully disassembled to
use the Race Clock Cover
3
Alzatex, Inc.
