5
3) Insert the latch on the top of the handle into the assembly hole on the bottom of the
control box. Then slightly push the control box in the direction of IN marked on the
handle to fix the latch in place.
4) Tighten the fixing screw.
5) Insert the search coil cable plug into the five-pin jack on the front control box’s
housing.
6) Lengthen or shorten the stem, so when you stand upright with the detector in your
hand, the search coil is level with and about 5-2 inches / 1-5 cm above the ground. After
that tighten the lock nut.
CAUTION:
•
The search coil’s plug fits into the connector only one way. Do not force the plug
or you could damage it.
•
Do not disassemble the stem lock nut. In case you disassemble it, place the
washer on the top of the stem connected with the handle with the small head of
the washer upwards. Then hitch the stem lock nut on the washer then tighten it
to lock it in place.
Adjusting the search coil
Loosen the knobs at the search coil’s end, adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough to
keep the search coil from rotating or wobbling.
Fixing Screw
Latch
Control Box
Assembly Hole
Small head
