7
Interruption of Work
ATTENTION! Never leave the scarifier unattended in the work area.
●
If you interrupt your work, store the machine in a safe place and disconnect it from
the plug! If you interrupt your work so that you can move to another work area,
always turn off the machine during the move. Move the compensation lever to the
transport position.
●
If you encounter an obstacle, turn off the scarifier and remove the obstacle. Inspect
the machine for damage and have it repaired if necessary.
Electrical Safety
●
Keep the extension cord away from the roller!
●
Never use the scarifier in the rain.
●
The connec
ting / extension cable must be checked regularly for damage and signs of
wear.
●
If a connected / extension cable is required, first disconnect the machine.
●
The extension socket for the extension cable must be waterproof to protect it
against water splashes and it must be made of rubber or have a rubber cover.
●
Extension cables must meet the requirements of EN / IEC 60884.
●
Use only approved extension cords with the appropriate cross
-
section cable. Consult
with your electrician.
●
Connecting accessories must be used for extension cables.
Electrical Requirements
●
Only connect the machine to a circuit that is protected by a fault protection switch (FI
switch) with a rated residual current of 30 mA.
●
Use only an extension cord with a sufficient
cross-
section that is approved for this
purpose. Use cables up to 40 m long.
●
Always fully unwind the cable drum before starting work. Check for signs of cable
damage.
DANGER! Do not connect a damaged power cord or touch a damaged cord until
it is disconnected from the plug. A damaged cable can cause electrical shock. If
a motor cable needs to be replaced, have it done by a specialist to avoid
danger.
Note: If in doubt, ask your electrician if the electrical installation in your home
meets these requirements.
●
Lay the power cord in a way in which the cord cannot be damaged and that it does
not interfere with your work.
