LP2 Surface/Wall Installation Guide
5 of 12
102-000027 - IG121818-A.0
LP2 Surface/Wall Installation Guide
Installation: Prepare Ceiling
ELECTRICAL WIRING:
A
T
MUST
See final/record drawings for mounting locations. Install
framing with consideration for alignment of wiring and
mounting locations.
1
See Final/Record Drawings for Mounting Locations
SAMPLE DRAWING
ELECTRICAL WIRING:
A
T
MUST
Install Canopy J-Box
(if using - sold separately)
at power
feed location per final/record drawing. Otherwise run
conduit/NM cable to powerfeed location.
2
Install Canopy J-Box/Wiring
SAMPLE DRAWING
Carefully remove lens using suction cup or similar.
3
Remove Lens
Remove heatsink/reflector screws that attach to housing.
Set aside.
4
Remove Heatsink/Reflector Screws
Installation: SMB - Surface/Back
Mount
Remove heatsink/reflector and hang over side of fixture.
CAUTION:
Do not apply excessive tension to wires.
5
Remove Heatsink/Reflector
SHOCK HAZARD! May result in serious injury or
death.
Turn power OFF at circuit breaker prior to
installation or servicing.
!
DO NOT PINCH OR PUT EXCESSIVE TENSION ON
WIRES
while joining sections or reattaching heatsink.
