Assembly instructions BR 133-3 to 139-3
Status 03/2022
Former instructions lose their validity.
11 / 14
•
In case of the optionally supplied
side rise
MA 200373, first re-
move the nuts and washers
A
in the area of the side doors.
•
Take the rise, fit it from below and screw it back with the wash-
ers and nuts. Tighten the nuts securely with the prescribed torque
(Fig. 383).
•
With the
fender bracket
option KS 320185, the brackets are pre-
assembled to the sub-structure with cross beams (Fig. 384). Screw
off the brackets. The threaded inserts remain in the cross beams.
•
Use fenders with flat assembly surfaces (not included in the scope
of delivery). Place the two parts of the brackets symmetrically in
longitudinal and transverse direction to each other on the assem-
bly surface of the fenders. The bevel must point upward.
•
Use the holes in the brackets as a drill template and drill the
fenders. Screw the components together with the screws MD 100265,
washers MD 110001 & nuts MD 120001.
•
Secure the fender bracket with the threaded inserts MD 100354
and the screws removed at the beginning to the cross beams.
Align the fenders centrally over the running-contact surface of the
wheel. Check if the tyre can move freely and correct as appropriate,
then tighten the screws with the appropriate torque (Fig. 385).
3.9 Completion work
•
Where appropriate, screw the hand grip to the inner right portion of
the frame pillar (Fig. 391).
•
Close the side screw holes on the rear pillar with the supplied plugs
MA150001 (Fig. 392).
•
According to wall-thickness, shorten the inside brackets
MA100068/-69 at the markers. Arrange these according to the
illustrations and fix with the screws MD100057. At the rear, any
preassembled screws must be removed beforehand (Fig. 393-395).
A
A
Fig. 383
Fig. 384
Fig. 385
Fig. 391
Fig. 392
Fig. 393
Fig. 394
Fig. 395
front
rear
rear
