System
•
Panel
• Troubles - shows all system troubles
• Status - shows all status updates
•
Touchpad
• Battery - shows battery level and charging information
• Network - shows network the Touchpad is connected to
• Access point MAC
• Wi-Fi signal strength - must not be less than 35
• Response Time
• Wi-Fi channel
• Touchpad Firmware
• Touchpad Hardware
• Updater Firmware
• Serial Number
• FCC/IC information
• Uptime
Settings
•
Display
• Brightness - adjust slide bar to change brightness level
• Auto sleep display - when enabled the Touchpad screen will go to sleep after programmed
period of inactivity. When disabled the Touchpad screen will stay on and show the system
overview page.
• Entry wake - when enabled the screen will turn on during entry delay
• Clean screen - ignores touch input on the screen for 30 seconds to allow user to clean the
screen
•
Sound
- adjust slide bar to change volume level
•
Touchpad
(must enter code to access)
• Show Favorites - display favorites menu that shows frequently used zones, scenes, and
devices on dashboard
• Show Panics - ability to turn off individual panics (this option can only be viewed when using
installer or dealer code)
• Lock to Dashboard
• When enabled only the dashboard menu can be accessed without an access code
• When disabled no access code is needed to navigate outside of dashboard
• Return to dashboard - specifies time of inactivity before Touchpad will automatically return
to dashboard
• Dock - specify the items to be displayed in the bottom dock
• Notifications - ability to turn on and off notifications on the system overview page
• Wi-Fi - connect via Wi-Fi if using cameras and user management features
• Temperature Scale - option for displaying
°F or °C
• Alula Cloud - must be logged into Alula Cloud as the account owner to use cameras and
user management features
• Power Off
•
Panel
(must enter code to access)
• Sensor Chime - enables or disables panel sensor chime mode (only available with )
• Quick Arm - arm the panel without entering your access code. Access code is still required
to disarm
