Install
using the 3M VHB® tape on the back of the
PINPad to adhere it to a wall.
• See Pro Tips for recommendations about using
3M VHB
tape.
• Two #4 or #6 screws may be used instead of,
or in addition to, the 3M VHB tape.
• The mounting plate can also be rotated 180
°
for table top use (See Pro Tips).
Operate
using the PINPad buttons. The PINPad LED will
blink when a button is activated.
Disarm
by entering a valid 4 digit user code on the
number pad.
Arm Away
by pressing the
AWAY
button until the
PINPad LED flashes red.
Arm Stay
by pressing the
STAY
button until the
PINPad LED flashes red.
Trigger a panic alarm
by pressing the
STAY
&
AWAY
buttons together simultaneously until the
Red LED briefly flashes repeatedly.
Pro Tips
3M VHB Tape
works great if the surface is properly
prepared and firm pressure is applied for over 10
seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50 °F
Reversible
mounting plate
allows for easy use on a
wall or table. For table top use, remove and reverse
the mounting plate and install the rubber feet
supplied.
To
replace the battery
insert a screwdriver into the
latch slot on either side of the PINPad and pop the
cover off the wall plate. Replace the battery and
reinstall the cover onto the wall plate.
Mounting Screw Holes
VHB Tape
VHB Tape
Arm Stay
Arm Away
LED