Altronix eFlow4N8DV, Installation Manual, Page: 9 / 16

eFlow6NV Series - 9 -
Door
Wire Strap
(from
Enclosure
to Door)
Battery and
AC Supervision
Circuit
CAUTION: When power supply board is set for 12VDC use only one (1) 12VDC
stand-by battery.
Keep power-limited wiring separate from non power-limited. Use minimum 0.25" spacing.
12AH Rechargeable batteries are the largest batteries that can fit in this enclosure.
An external battery enclosure must be used if using the 40AH or 65AH batteries.
Switch Detail
L
G
N
NC
C
NO NC
C
NO
BAT FAIL AC FAIL
---
DC
+
AC
AC1
DC
---
BA
T
+
– AUX +
TRIGGER EOL
SUPERVISED
5A 250V
RESET
GND NO
disable
enable
2 hr.
1 min.
AC DEL
AY
SHUTDOWN
O
N
220VAC
power mains
Green
Lead
(ground)
Battery
connections
DC Output to devices*
(refer to Fig. 3a, 3b
for board configuration pg. 6)
PD8/PD8CB
DC Output to devices*
(refer to Fig. 3a, 3b
for board configuration pg. 6)
PD8/PD8CB
OFF --- 24V
ON --- 12V
ON
ON
1
Switch On - 12V
Switch Off - 24V
Optional Rechargeable
Stand-by Battery
Optional Rechargeable
Stand-by Battery
Edge of
Enclosure
to Access Control
Panel or
U.L. Listed
Reporting
Device
Enclosure
Sentrol
model # 3012
Tamper Switch
or equivalent
(Not Included)
Fig. 8 - eFlow6NXV configuration