Altronix eFlow4N8DV, Installation Manual, Page: 5 / 16

eFlow6NV Series - 5 -
Fig. 1 - eFlow6NV Board configuration
Trouble/Time Limited Warning of Stand-by Batteries:
The Time Limited Warning circuit must be connected for local or remote annunciation with an Amber or Red LED to indi-
cate DC Trouble (low battery, loss of battery or when 95% of the stand-by battery has been depleted). Connect the circuit
to the Batt Fail relay contacts to an appropriate input of a Burglar Alarm or Access Control Panel. The following figure
shows the circuitry needed for local annunciation.
Fig. 2 - Battery trouble indication -
For Canadian use, a red indicating lamp must be visible from the exterior of this enclosure.
Wire one leg of a power source to the indicating lamp. Wire the second leg of the power source to the indicating lamp in
series with the battery fail relay contact terminals marked [BAT FAIL - C, NO] (Fig. 2, pg. 5).
L G N
NC C NO NC C NO
BAT FAIL
AC FAIL
---
DC
+
AC
AC1
DC
---
BA
T
+
+ AUX –
TRIGGER EOL
SUPERVISED
5A 250V
5A 250V
10A 32V
10A
NO GND
RESET
enable
disable 1 min.
2 hr.
AC DELAY SHUTDOWN
O
N
1a 1b
1g
1h
1e 1f 1d 1c
1i
OFF
---
24V
ON
---
12
V
ON
NC C NO NC C NO
BAT FAIL AC FAIL
POWER
SOURCE
RED INDICATING
LAMP