Alton VICTORIAN OAKHAM, Instruction Manual

Page: 22 / 64

22
Frame Assembly
5
Before you position your side section onto the dwarf wall you should drill the pilot holes in the
bottom of the side corner bars shown in diagram 27. The position of these holes should be about
19mm from the side face and 30mm measured from the bottom end of the bar.
You can now position the side section on the aluminium base, you will need a helper to hold this in
place or simply strap it to a set of steps.
Now offer the front gable to the side assembly
slotting the corner bar onto the end of the eaves
bar, do not fix this joint as it will be done at a later
stage (diagram 28). Screw the bottom of the corner
glazing bar to the end of the cill (80mm screw)
making sure the rebate for the glass lines up with
the front face of the side cill (diagram 27).
Dia. 28
Dia. 27