40
Work Bench Installation (Optional)
21
N.B.
The workbench height is set at
900mm from the floor (diagram 96). If
you wish to install this at a lower position
all you need to do is cut the work bench
leg(s) to suite.
Start by marking the internal frame on
each vertical member at 900mm that will
come into contact with the workbench.
This will help you line up the end mounts
and workbench sections.
Drill pilot holes and fix the end mounts in
place with 80mm countersunk zinc plated
screws.
Diagram 96
Diagram 97
Hold the first workbench sections in place,
line it up with the marks you made on the
internal framework and fix it with 60mm
countersunk zinc plated screws (diagram
98). To attach a workbench leg to support the loose end of the workbench, first you must drill 2 pilot
holes through the tenoned end, use 40mm countersunk screws to fix in place (diagram 97). Check
the leg is upright and fix to the floor diagonally through the back face.
Dia. 98
AB0663
900m
m
AB06
57
Summary of Contents for EVOLUTION FUSION
Page 1: ...1 04 18...
