12
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
9097421000(1)2008-01 A
ENGLISH
USER MANUAL
BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET OR GEL)
Set the electronic board of the machine and of the battery charger according to the type of batteries installed (WET or GEL), as
shown below:
Machine setting
Turn the ignition key (41) to “I” and pay attention to the following in the very first seconds of machine operation:
If the green warning light (37a) is flashing, the machine is set to GEL.
If the red warning light (37c) is flashing, the machine is set to WET.
To change the settings, proceed as follows.
Turn off the machine by turning the ignition key (41) to “0”.
Press and hold the switch (36), then turn on the machine by turning the ignition key (41) to “I”.
Release the switch (36) at least 5 seconds after starting the machine.
Within three seconds, press the switch (36) again for a few seconds and check that the warning light for the required setting is
flashing.
Battery charger setting
Remove the screws (A, Fig. 1) and the panel (B).
Turn the selector (C) to WET or GEL according to the type of batteries installed.
Install the panel (B) and tighten the screws (A).
Figure 1
S311218A
Battery installation
Open the covers (51 and 58) and check that the tanks (60 and 61) are empty, otherwise empty them through the drain hose
(10) and the tap (24).
Close the covers (51 and 58).
Carefully lift the tank assembly (71).
Install the batteries and connect them according to the diagram (76).
WARNING!
If a battery box is installed, place it on the left side of the machine, to allow the tank assembly (71) to be
closed correctly.
Battery charging
Charge the batteries (see the procedure in Maintenance chapter).
1.
•
•
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Summary of Contents for SCRUBTEC R 361
Page 108: ......
