Alto MX-30, User Manual, Page: 11 / 16

9
3.3.3 GND Screw
GND is the supplementary grounding selection for other connected instruments.
3.3.2 POWER Switch
This switch turns the Mixer ON and OFF.
3.3 The Rear Panel
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
AVIS: RISQUE DE CHOC ELECTRIQUE
- DO NOT OPEN
- NE PAS OUVRIR
PHONO LINE PHONO LINE TAPE BOOTH
POWER
GND
L
R
GND GND
MAIN OUT INPUT 2 INPUT 1 INPUT 3 EFFECTS
PHONO LINE
RETURN
TO MAIN
SEND
FROM PFL
AMP
PHONO
LINE
PHONO
LINE
PHONO
LINE
AC INPUT
EUROPE
210-240V
50Hz
Fuse:T315mAL
ON OFF
MODEL SERIAL
RATED POWER CONSUMPTION: 25W
Apparaten skall anslutas till
till ett natverk
jordat uttag nar den ansluts
Useonly with a250V fuse Useonly with a250V fuse Useonly with a250V fuse
USA / Canada
100-120V 60Hz
Fuse:T500mAL
UK / Aust
240V 50Hz
Fuse:T315mAL
3.3.4 MAIN OUT
The AMP, BOOTH and TAPE outputs are RCA type connectors. Yes the same largely used in hi-fi and are low
impedance.
Through the AMP output , you can connect your MX-30 to an amplifier, and the level will be controlled by
OUT A on the Top panel;
Through the BOOTH output , you can connect your MX-30 to an additional amplifier and/or loudspeaker
system and the level will be controlled by OUT B on the Top panel;
Through the TAPE output , you can connect your MX-30 to a tape recorder. The tape level is fixed, so you
should adjust the input level of the recorder.
24 26 25 27 28
23 29 30 32 33 31
24
3.3.1 AC Inlet and Fuse Holder
Use it to connect your MX-30 to the main AC with the supplied AC cord. Please check the Voltage available
in your country and make sure the voltage is identical to the values marking on the product. Replace the fuse
with the same type by the qualified personnel only.
23
25
26
27
28