6
4.2 Memory Initialization
1. To activate the MEMORY PULL function the DOWN, SEL and ENTER must be activated and kept down during
turn-on.
2. At turn-on the display shows AL. which indicates that a complete memory initialization is in progress.
3. If a power failure occurred while the machine was saving some data to memory, the memory is partially initialized
to avoid inconsistent data that could cause the machine to behave improperly.
4. After one or two minutes, the display will change to show the default preset 01.
a l .
4.4 Communication
1>.When the MAXI-Q PC is connected by its RS232 port to a PC running the MAXI-Q PC editor program, the
display shows CG (Comm. Gateway).
2>.When the MAXI-Q PC is connected by its RS485 port to another MAXI-Q PC running as a gateway, the display
shows CS (Comm. Slave).
C G
C S
4.3 Firmware Update
When you use "Maxi-Q Editor" and see the message "Please Update The Program To Maxi-Q PC Version X.0",
you have to update its firmware.
The update steps as follows:
1. Turning on the Maxi-Q PC and press "SEL"+"ENTER"+"UP"keys at the same time, you will see the message
"U.P" showing on the segment.
2. Restart the "Maxi-Q Editor" and choose the "On Line" function. You will see the message "Maxi-Q PC VERSION
X.0. Do you want to update?" showing on the Maxi-Q Editor. Then press the "OK" button and it will start to update
the Firmware.
3. The Maxi-Q PC will show the update procedures on the segment as follows:
1>. Download ("do").
2>. Flash Erase (No show on the segment).
3>. Flash Program ("pg").
4>. Update OK! ("dn").
After finishing firmware update, you must restart the Maxi-Q PC to complete the update procedures.
Meanwhile, the system will restore the exact operating conditions at the time of switching off.
Click the SEL key to select proper PRESET or ID status.
When PRESET LED lit, you can use the UP and DOWN keys to select factory preset (1-10) or user preset (1.
~ 128.), then you will find the data on display twinkling all the while.
When ID LED lit, the display will show the ID number. You can use UP and DOWN keys to set a ID number (1
~ 32) for this unit, and the data is twinkling all the while.
Press ENTER, the display shows the PRESET/ID loaded in the units memory.
1
(Example: Factory PRESET)
6 4 .
(Example: User PRESET)
