1. INTRODUCTION
2. FEATURES
3.1 The Front Panel
3. CONTROL ELEMENTS
4
Single rack unit
2 COMBO input connectors are compatible with balanced XLR and JACK
2 outputs with balanced XLR connector
A/D and D/A converters for a 117dB dynamic range
Delay lines up to 2715ms for each channel
10 Factory presets and 128 user presets by large memory capacity
Switching power supply
Remote control
Manufactured under QS9000, VDA6.1 certified management system
6
4
Your MAXI-Q PC is a 30+30 Band Digital Equalizer and it also is a powerful versatile signal processor. you can set
the input and output configuration only through recalling one of the presets included in the internal memory or PC
Editor software. Thanks to the use of selected and expensive components, the MAXI-Q PC is worth much more than
its price.
2
3
5
ON
OFF
POWER
ENTER
UP
SEL
DOWN
RS232
PRESET
ID
R
LTO
30 30 BAND
DIGITAL EQUALIZER
1
1. Power Switch
The switch is used to turn the main POWER on and off.
Note:
Before turning on the unit, please make sure the amplifiers of sound system are off to avoid the annoying
and sometimes dangerous signal peaks.
2. LED Display
The both LED indicate the selecting status; one is for PRESET, another for ID.
3. UP/DOWN Keys
There are 10 factory presets, 128 user presets and 32 ID selections. The both keys are used to allow you to
turn over the variable presets or ID selections for achieving the proper one.
4. SEL Key
Activate the SEL key to select required PRESET LOAD or SET COMM. ID functions.
5. ENTER Key
The key allows you to access to the selected preset or ID selection.
6. RS232 Serial Communication Port
The RS232 port allows incoming and outgoing communication between the MAXI-Q PC and a PC. Via conne-
cting the MAXI-Q PC to a PC, all the functions are possible to be control remotely by ALTO editing software.
1>.Ensure that power to the MAXI-Q PC and the computer is switched off.
2>.Connect the MAXI-Q PC to the PC's RS232 serial port using a data cable with 9-pin female plugs. The re-
quired data cable is known as a 'null modern' (also data transfer) type serial interface cable. Attach the other
end to the 9-pin socket situated next to the audio output terminals of the MAXI-Q PC.
3>.Turn on your audio system, including the MAXI-Q PC. Now boot up your computer and run the PC editor
(see "Configuration of the system").
