Alto DJM-4, User Manual, Page: 8 / 15

3.1.2 The MAIN OUT Section
MIN MAX
SURROUND
SURROUND ON TALK ON
MIN MAX
TALK
OUT B
BAL A
OUT A
LEFT RIGHT
MIN MAX
OFF MAX
MAIN OUT
MIN MAX
SURROUND
SURROUND ON TALK ON
MIN MAX
TALK
OUT B
BAL A
OUT A
LEFT RIGHT
MIN MAX
OFF MAX
MAIN OUT
7
10
11
12
13
14
16
15
17
18
-. The SURROUND control
DJ Mixers are often used in quite inappropriate venues and
the positioning of the loudspeakers is not always optimal.
The Surround Control allow you to get a better transparency
and stereo image and will contribute to "clean" you mix.
15
-.The SURROUND ON switch
You can turn off the Surround function via this switch. You
can also run fast A/B comparison (with surround/without
surround) via this switch.
16
3.1.3 The PFL Section
-.LEVEL control
17
-.The PFL MIX control
18
+10
+7
+4
+2
0
-2
-4
-7
-10
-20
LEVEL METER
+10
+7
+4
+2
0
-2
-4
-7
-10
-20
LEVEL METER
20
3.1.4 The LEVEL METER Section
-.LEVEL METER
This 10 segments LED's Meter will monitor the output level.
20
19
-. The OUT A control
10
The OUT A control is used to adjust the main level of the AMP
output on rear panel.
-. The BAL A control 11
The BAL A control is used to adjust the stereo balance of the
AMP output on rear panel.
-. The OUT B control
12
The OUT B control is used to adjust the main level of the
BOOTH output on rear panel.
-. The TALK control
13
When you speak through a connected microphone, the volume
of the reproduced music will be automatically reduced by the
mixer for better intelligibility of your voice. You can determine
yourself how much the volume of the music will be reduced
via this control. You can turn off the TALK function via this
button (14).
-.MODE switch
19
This is a 2-position switch. When the switch is in STEREO
position, the PFL MIX control will fade between PFL signal and
MAIN output. When the switch is in SPLIT position, the PFL
MIX control has no influence on the PFL signal.
When set the switch mode (19) in STEREO position, you can
fade between PFL and MAIN output.
This knob will adjust the level of the headphone signal.
When you connect a headphone to your DJM 4 you have the
chance of pre-listen the audio signal before the signal reach
the Main output.