Alto DJM-4, User Manual, Page: 10 / 15

3.2 The Front Panel
MIC
IN
PHONE
OUT
REVERSE HOLD
REVERSE TAP
CROSSFADER
CURVE
SMOOTH SHARP
BASS MIDDLE TREBLE
KILL HOLD KILL HOLD
KILL TAP KILL TAP
BASS MIDDLE TREBLE
9
26 27
28 29 30
3.2.1 The KILL Function 26
3.2.2 The REVERSE Function
27
3.2.4 CROSSFADER CURVE Control
Via this knob you will adjust the crossfader curve. Please see (8) earlier in this Manual for further reference.
29
3.2.5 The PHONE OUT Jack
This input will accept a standard headphone with a 1/4" stereo jack.
30
3.2.3 MIC IN Jack 28
The KILL function is used to attenuate the three frequency bands: BASS, MIDDLE and TREBLE. There are
three modes: TAP, CENTER and HOLD.
There isn't KILL function in the CENTER position;
In TAP position, the function is triggered instantly and the switch will return to the center position as soon as
you release it.
In HOLD position, the function will be locked in the HOLD position. To cancel the effect you will need to push
back the switch in the center position.
The left and right KILL function are assigned to the CH 2 and CH 3 respectively. There is no KILL function for
CH 1.
Like the KILL function, there are three modes for the REVERSE function (TAP, CENTER and HOLD). It is used
to invert the direction of the crossfader so that an immediate inversion of CH 2 and CH 3 will be achieved.
This input will accept any unbalanced low impedance microphone. The functions of the microphone will be
controlled by the CHANNEL section on the Top Panel.