XCELERATE SERVICE INSTRUCTIONS • XLSERVICE • 17.
w w w . a l t o - s h a a m . c o m
|
8 0 0 - 5 5 8 - 8 7 4 4
|
2 6 2 - 2 5 1 - 3 8 0 0
Xcelerate™ Hi-Speed Oven
CHECK mICROWAVE
STEP 1: TEST hEATING FUNCTION
Cool down the oven and set “SET TEmP” in “SERVICE
mODE” to 68°F (20°C) to deactivate convection heating.
STEP 4
When finished stir the water a bit and measure the
temperature again. The water should be approximately
59°F (15°C) warmer than before. This value may vary
depending on ambient temperature, line voltage and
water container. If you have this temperature increase the
microwave works properly.
If there is a problem with the microwave you will not have
a temperature increase at all or only a minor increase of
less than 41°F (5°C). In this case continue with amps
measurement.
STEP 5: AmP mEASUREmENT
Disconnect the main power. Open the right side panel of
the oven. Clamp your amp meter to the cable S32 near
the door switch. (Do not measure near the transformer
or microwave. The voltage, high frequency and magnetic
fields can interfere and prevent getting an accurate
reading).
STEP 2
Place a
plastic bowl
with about one liter of water into the
baking chamber. measure and note the temperature.
STEP 3
go to “mANUAL mODE” and set the parameters
tiMe 2:00 minutes
teMP 68°F (20°C)
air 10%
MiC 100%
then press “START”