Alto-Shaam FryTech ASF-60G Manual Download Page 7

Page: 7 / 78

Gas Fryer Operation & Care Manual • 6

I N S T A L L A T I O N

1. It is the responsibility of the installer to verify that this

fryer installation is in compliance with the

specifications listed in this manual and with local code

requirements.

2. Hood installation is required.
3. Both cooking and cleaning functions require

unobstructed access. The frypot, control panel, and

front access door must be maintained free from

obstruction. The access door must be accessible for

service and maintenance.

4. Locate the fryer on a firm, level surface ONLY. The

area surrounding the fryer must be kept clear of all

combustible materials.

FOR YOUR SAFETY DO NOT

store or use any

flammable liquids or allow flammable vapors in the

vicinity of this fryer or any other appliance.

FOR YOUR SAFETY DO NOT

place insulation

or any other type of materials in clearance areas.

7. When properly installed, the electric fryer is designed

for operation adjacent to non-combustible floors and

walls with a 6" clearance at the back. Clearances from

all combustible construction is a minimum of 6"

(152mm) at the back and both sides. Concrete, tile,

terrazzo, or metal surfaces are recommended. Metal

over a combustible material may not meet code for

non-combustible surfaces. Verify site selection with

local codes for specific requirements.

Doit être utilisé seulement sur des planchers non

inflammables.

8. Adequate means must be provided to limit the

movement of this appliance. A restraining device is

required for field installation.

9. DO NOT install this fryer in any area where it may be

affected by any adverse conditions such as steam or

dripping water, etc. DO NOT install the fryer over a

drain.

10.

ASF-75G LEVELING:

Make certain the

fryer is positioned firmly on all four

supporting casters. Level fryer front-to-

back and side-to-side by loosening the jam

nut on each leveling caster and turning the

caster. Restraining ties can be used for

stabilization if necessary.

Locking casters are located at the

front of the fryer. To unlock the

front casters, pull the locking pin

away from the caster assembly and

twist the caster to the unlocked position.

To relock, repeat this action and twist the

caster until the pin resets back into the

locked position.

11.

ASF-60G LEVELING:

Make

certain the fryer is positioned firmly

on all four supporting casters. Level

fryer front-to-back and side-to-side

by holding lower collar (#2) while

twisting upper collar (#1).

Restraining ties can be used for

stabilization if necessary. Use an allen

wrench (#3) to lock caster in position.

BURN WARNING:

Make certain the

fryer  is  stabilized  before  operation  to
prevent  any  movement  or  tipping  and
the  possibility  of  severe  burns  caused
by hot, splashing shortening or oil.

Fire may be the result of improper
installation. Carefully read and follow
all installation instructions located in
this manual.

LOCKING SCREW

S I T E I N S T A L L A T I O N

C A U T I O N

TO PREVENT PERSONAL INJURY,

USE CAUTION WHEN MOVING OR

LEVELING THIS APPLIANCE.

D A N G E R

To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70. In Canada, all
electrical connections are to be
made in according with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.