Page 9
SS-UV40
Installation & Users Manual
Installation And Setup
Connecting Data
Connect DMX signal to the fixture using the XLR connections. The DMX signals can be daisy chained from one
enclosure to an adjacent enclosure each with separate connections to a power source.
Access the control board by loosening the three brackets securing the top cover.
Connecting Power & Power Requirements
CAUTION - The power & control enclosure must be wired to a grounded source of power con-
nected to a GFCI circuit breaker for outdoor installations.
CAUTION - Do not use the SS-UV40 on a dimmable circuit.
The SS-UV40 requires 45 watts of power at 120VAC. The fixture is supplied with bare-end power cable is
ready for wiring to permanently installed junctions or can be wired to plugs for temporary use.
Mounting Control Enclosure & Modules
Mounting brackets are provided on the UV LED module for permanent mounting to a wall, floor or ceiling.
Use proper length screws or bolts to mount the module in the desired location using all four mounting holes
provided on the UV LED module brackets. Note that the brackets can be removed and reoriented for easier
access to the mounting holes.
Mounting brackets are also provided on the Electronics power and control box for permanent mounting to a
wall, floor or ceiling. For wall mounting, the box should be oriented so that the hinge is on the top for proper
access to the control board and for better resistance to water splashing. Use proper length screws or bolts to
mount the box in the desired location using all four mounting holes provided on the outdoor enclosure.
Focusing
With the fixture energized and Data connected, point the unit in the direction of the object to be irradiated by
loosening the two screws at either end of the UV LED modules. Adjust the UV LED module to the desired posi-
tion and secure the fixture by tightening the two screw to lock down the UV LED light module.
